Driver’s door update!

(03/18/2023)

I’m fairly close to having the driver’s door done. In fact the only things left are to figure out if/how I can Dynamat the door and make a spacer for the 6×9. Yes, the speaker is quite bulky for the door, but I like it and want large speakers in the front. So there.

Here’s how the power mirror’s original plug/wiring was:

The Ampseal connectors I’m using elsewhere in the car will not fit in the small hole in which the wires have to pass, so I am using these Molex Squiba connectors. Actually, they are a little too small, but they did do the job.

All put together I have a nice harness whereby I can remove the mirror, or the switches, all with locking connectors.

Back at the car, I have put in the rivet nuts and painted the bracket for the power lock. Now this is installed for good!

From here I started installing the other wiring harnesses in the door and passed the mass of cables through the gland at the door jamb.

After that, I set the door card on the door to see how things fit/looked!